Wheel spacers

[Bigdog800EFI]

Paul can you make a wheel spacer to fit on a 3 on 3 bolt pattern to convert to a 4 bolt pattern. Either 4/110 or 4/156

[Rubberdown]

sURE, i MADE A SET FOR A BUDDY THAT HAD A 3 BOLT PATTERN TO MOUNT SOME HONDA WHEELS ON A KIDS QUAD ONCE, AND A SET OF 3 BOLT FOR AN OLD 3-WHEELER TO MOUNT YAMAHA WHEELS ON THE BACK.

Woops, sorry bout the caps.

I would need to know what diameter the 3 studs are, the bolt circle they are on, and if possible, a picture of the hub the wheel spacers will mount against to make sure I have clearance in the center of the spacer. Then I need to know what size studs you want pressed in, and what bolt pattern/circle.

Peice of cake buddy ;)

[Bigdog800EFI]

This guy may call you directly. His name id Josh and he owns that PRF forum you logged on to. May be a good way for you to get on his Ranger site as a sponsor. Barter system. I will send him your way.

[Rubberdown]

Shoot ya, send him my way, I could trade some advertising for some custome conversion spacers!!!!

[Turk]

I know i've asked this once before but what is the thinest wheel spacer you can make?If I remember correctly I think you said 3/4 ".I assume a 1/2" spacer is impossible.

[Rubberdown]

Turk, if you go too thin, the original studs in your hub will protrude out into the wheel. If you go to thin, you will not be able to get the studs in the spacer pressed in flush with the back face on the spacer, or you will have the knurl from the new studs sticking out past the mounting face for the rim.

[Turk]

Saftey first for me.Sounds like a 1" is the thinest spacer possible.