2006 750 bruteforce fam quit

[mike2449]

I have 2006 750 bruteforce and the fan quit work is their a fuse for this thanks for any help you can give

[Tonymarucio]

Yes there is a breaker under the seat in the middle some where the little pin pops out you just have to push it back in if you did not fry the fan motor itself

[mike2449]

Ok thanks no I tested the fan

[swampthing]

puttin a manual toggle switch in for your fan is always a good idea if you run in deep mud or water......even a little.

[Tonymarucio]

Ok thanks no I tested the fan

Np mang

[Tonymarucio]

Hey dion how did you hook up you fan switch??

[BrutemanAl]

I just did my fan switch and temp gauge in the spring , I ran both wires for the switch to the temp sensor on the top left (if your sitting on the bike) of the rad , works great !!

ps... Tony seen u on another site MIMB , there is a how to on the temp gauge and fan switch mod .

As for that pesky little beaker under the seat .... get ride of it , go to an auto supply store and but a fuse holder and solder the wires on the new fuse holder to the factory wires and throw in a 15 amp automotive fuse . Works like a charm.

[swampthing]

Hey dion how did you hook up you fan switch??

^^so easy it's sick! you can run off your fuse box or straight off yer battery (that's what I did) and just make sure ya got a good ground and an in-line 15 amp fuse on the pos. wire n yer good to go.