Wet Clutch my problem??

[mbplayer]

Hey guys got an 07 660 rhino. My cooling fan on my rad quit working on me the other day and my dash is burnt out so I never noticed till I was in some mud and had no power i would say about a mile of riding hot. Checked the motor 130 psi compression. So I would assume its fine. Starts and runs good still. But here is the problem when I try to move forward or backwards it revs like crazy and slowly picks up speed?

Could this be the wet clutch? and if so anything I should do while I am in there? This machine has a 686 big bore kit, alba performance exhaust system. I am running 27x12x12 mud lites all around with a 3" lift. I mostly ride trails with my wife and kids but also play alot in the mud with the buddies on the weekends. Plans are to go to a set of 30" zillas.

Thanks for the help

MB

[The Kid]

put stiffer springs in the wet clutch while your there

[wildhigh]

sounds like it hope u have a spare grand

[Bad Kitty]

Drain the oil and C how much of the clutch material is in it. Wet Clutch and BBK don't mix IMO anyhew. Could be something else binding up, maybe in secondary. Did U look at everything? If it's like a Cat, just lean the bike over so oil don't come out and take the clutch out. Only way to C if it's in good shape, may be able to C in motor if there's crud in it. All just MO of course.

[wildhigh]

been there done that its that or grooves on your sheave or dirt built up real easy to check ive owned two of them

[mbplayer]

Well after we took it apart we found it was my primary. New grizzly sheave and greaseless 16 gram weights on the way. Should make a big improvement from the sheave i was running before.

MB