PDA

View Full Version : Quadovator temp gauge

BIG_T
12-24-2007, 03:42 PM
I just installed the quadovator temp gauge on my dad's Ranger. it would taken me about a half hour except I had to run a wire special on the Ranger. Very quick, very easy. I'll get some pics up sometime soon.
Turk
12-24-2007, 05:42 PM
So far so good with mine.I love having it.
Rubberdown
12-24-2007, 08:53 PM
same here turk, I love it on my sportsman....
BIG_T
12-24-2007, 09:14 PM
I'm thinking this will be another good addition for me to have on my bike. Sounds like Mark will be doin it soon too. The only problem will be finding room on my pod.
Rebel64
12-25-2007, 10:07 AM
Glad you had a successful install with it Tim.
Turk
12-26-2007, 08:16 AM
I'm thinking this will be another good addition for me to have on my bike. Sounds like Mark will be doin it soon too. The only problem will be finding room on my pod.

You should have the room on the pod for the temp gauge.

Here's a picture of where I put mine.
http://pic20.picturetrail.com/VOL144/1427015/16921545/288839116.jpg
BIG_T
01-02-2008, 09:38 AM
I've got more switches on my pod than you do.
Turk
01-02-2008, 10:52 AM
I've got more switches on my pod than you do.


Is that because yours is a X2 ??Do they have more switches ??or did you add accessories??

I've got to put my rear light switch back into my pod somewhere below the handle bar line right now it's zip tied onto my handle bars by the brake line.
BIG_T
01-02-2008, 12:15 PM
Why not put another hole in your pod below the other two switches? I'm thinking you should have enough room there.
The X2 doesn't have any more switches on it, except for the turf mode on the the AWD switch.
I have hand and thumb warmers on my bike, and the rear worklight, plus I'm plannin on puttin some more stuff there like more lights, reverse override, etc. I might still have enough room, just gotta check it out more closely when I get around to it.

Do you know of anyone that has put a oil pressure gauge on a 500? My dad wants one for his 500 Ranger, but I'm not sure if there's a good place to tie into.
Turk
01-03-2008, 06:55 AM
Why not put another hole in your pod below the other two switches? I'm thinking you should have enough room there.

I've been looking at putting it there below the other two switches.I just need to check and make sure there is enough clearance with the handle bars,it would be pretty close but i'm going do some measuring before I cut.